Technical parameters: Pressure: 0.4-0.6MPa Power: 10W Power: 220 / 110V 50 / 60Hz Filling speed: 10-30 bottles / min Filling Accuracy: ≤ ± 1% optional models: 5-60ml 10-125ml 25 -250ml 50-500ml 100-1000ml 250-2500ml 500-5000ml Kerry collar single-head liquid filling machine, the introduction of advanced foreign technology, based on independent innovation and transformation of the unique liquid filling material filling the new device. Equipment when filling material has anti-drip, anti-corrosion, anti-pull and lift the filling device characteristics, etc. The machine pneumatic original parts are used in Taiwan AirTac or Germany FESTO pneumatic components. (Can be customized according to customer demand) are all-body 316 and 316L stainless steel exterior structural design is reasonable, easy to operate, easy disassembly, cleaning is very convenient. Filling volume and filling speed can be adjusted, filling accuracy, and can be widely used in daily chemical, pharmaceutical, chemical, food and special industries. Maintenance of common sense: a machine can not be started: a power, turn on the power switch, check the fuse. 2. Release the emergency stop button. 3. Turn on the pressure, remained at around 6 kg. 4. Check whether the switching power supply DC24V power output. 5. Check the touch screen and PLC communication cable is loose. II: less than expected: 1 Check the air pressure, check the touch screen maintenance mode screen. 2. material mouth is closed, check the circuit. 3. feeding. 4. Check the air pressure, check whether the injection cylinder and the cylinder and die, touch screen repair under way to check the screen material mouth is closed, check the circuit. Three: Filling dose allowed: 1. Check the feed system. 2. materials for filtration, cleaning pipes. 3. Replace the pneumatic valve seals, pipe leak, replace the pneumatic valve. 4. Clean the solenoid valve, replace the solenoid valve. 5. Cleaning gas muffler replacement muffler gas. 6. Adjust the valve to reduce the impact, increasing dive depth. 7. Replace the O-ring. 8. Adjust the injection cylinder magnetic switch. Four: Leak: a tight upper and lower feeding mouth, cutting nozzle gasket replacement. 2. Replace the lower tube. 3. Clean pneumatic valve, pneumatic valve gasket replacement. 4. Replace the injection cylinder seals.